HVL 2.015 – 4.220 5th generation Hydrovar motor mounted pump controller up to 22 kW

Hydrovar is the intelligent pump controller that matches the performance to the demand. The system consists of a variable speed drive, a control card, sensors, EMC filters and motor/system protection. There’s no need for an external control panel when using Hydrovar.

The Hydrovar is easily mounted directly on the motor of the pump and will fit on any standard IEC motor. This makes the Hydrovar an excellent choice for retrofitting and upgrading of fixed speed systems.

Easy to commission

The quick start up guide and logic menu system makes the Hydrovar easy to set up and operate. Advanced programming features allow optimizing the Hydrovar for almost any duty condition.

Energy savings potential

A motor running at 80% of its maximum speed uses 48% less energy. With energy savings of up to 70% on partial loads alone, the typical investment payback period is less than two years depending on energy costs and pump operating times.

Control offering:

Multi-pump capability from 1 to 8 pumps
Constant pressure
Constant flow
According to system curve
Via an 4-20 mA or 0-10 V external signal
Safety:
Fulfills EN 61000 standards
Embedded THDi filter to reduce harmonic interference
Stop the pumps at zero flow
Integrated soft start/stop: no water hammer and lower starting current
Built in protectionOver/under voltage
Overcurrent/ output short protection
Low water level
Sensor failure
Motor over temperature
Inverter over temperature
Minimum threshold/ conveyor limit

Specification:
Power: from 1,5 kW to 22 kW
Power supply: single or three phase 50 or 60 Hz
Communication: RS485 interface, BACnet, Modbus, Wi-Fi card (optional)

HVL 2.015 – 4.220 5th generation Hydrovar motor mounted pump controller up to 22 kW

Documenten

Technische tekeningen

Selectie tools